CHECK OUR EXAMPLES OF CHECKING FIXTURES

Checking fixture for handbrake reinforcement

Complete Go/No Go checking fixture for handbrake reinforcement assembly

  • Control of LHD and RHD versions
  • Control of the part deformation and of the location of the holes by Go/No Go pins
  • Identification of the different control areas by colour codes

Checking fixture for handbrake reinforcement component

  • Fixation of the part by conic centring elements and clamps
  • Control of the deformation and of the location of the holes by Go/No Go pins

Checking fixture for clic fit housing

  • Fixation of the part by two sliding systems positioning the part in the middle of its fixation plane.
  • Control of the part deformation and of the location of the holes by Go/No Go pins

Description

Control of the deformation and of the punched holes of the part by Go/No Go pins or dial indicators. This control is essential to make sure that all the elements of the reinforcement assembly after the welding process.

Materials and tolerances

Our checking fixtures are produced in aluminium, the components submitted to wear-and-tear are produced in steel. Tolerances for RPS (fixation points) and dial indicator points: ±0.05mm. Tolerances for simulation blocks: ±0.1mm.

Documentation delivered

Minimum documentation: dimensional report of your checking fixture, 2D assembly drawing, assembly CAD.  Optional documentation: R&R report, user manual, stabilization certificate.



For more information and estimates