Gear lever housing trim | Tecnomatrix

CHECK OUR EXAMPLES OF CHECKING FIXTURES

Gear lever housing trim
Home » checking fixtures » Reinforcements and brackets, pedals and levers » Gear lever housing trim

Automated fixture for gear lever housing trim

Positioning of the part by centring blocks and clamps
Control of the deformation of the outline of the part by automated probes: all the probes are connected and activated simulatenously by pressing one button.
The values measured are automatically sent to a data acquisition PC storing the values and indicating to the user if they are within or out of tolerance according to the control tolerances defined in the measurement programme.

Description	Although a relatively simple part, the outline of gear lever housing trims is crucial as part of the visible parts of the gear lever assembly.
Materials and tolerances	Our checking fixtures are produced in aluminium, the components submitted to wear-and-tear are produced in steel. Tolerances for RPS (fixation points) and dial indicator points: ±0.05mm. Tolerances for simulation blocks: ±0.1mm.
Documentation delivered	Minimum documentation: dimensional report of your checking fixture, 2D assembly drawing, assembly CAD. Optional documentation: R&R report, user manual, stabilization certificate.
Cycle time and traceability	The automated probes can be easily replaced by dial indicator points measured with CAPTOR-S system. In order to prevent any confusion during the measurement process, this system can be complemented by CAPTOR-C detection technology.

For more information and estimates