Number plate
Scuttle grilles may consist of a single part assembly, or of two non-symetrical parts. Checking fixtures for scuttle grilles may control the fixations of the part, their fitting in the car environment and their fitting against the windshield.
Our checking fixtures are produced in aluminium, the components submitted to wear-and-tear are produced in steel. Tolerances for RPS (fixation points) and dial indicator points: ±0.05mm. Tolerances for simulation blocks: ±0.1mm.
Minimum documentation: dimensional report of your checking fixture, 2D assembly drawing, assembly CAD. Optional documentation: R&R report, user manual, stabilization certificate.
Though number plates fixtures are not part of the most complex checking fixtures for car parts, they still have at least 5 dial indicator points. This means that the part will be fully checked, but also that the operator in charge of the measurement of this part will need time to carry out all the measurements, write them down and then transfer all this data to his company data base. This process can be automated and made easier and faster: for your number plates fixtures, think about using CAPTOR-S and CAPTOR-C.
Number plate checking fixture: part mounted
Number plate checking fixture: rear part
Number plate checking fixture: part dismounted
Our packaging for checking fixtures
